Removal and installation
| PERFORMANCE ORDER |
| 1. Lift redock of the car and remove a wheel. |
| 2. Remove a support and колодки, fix a support. |
| 3. Remove a support arm. |
| 4. Unblock and remove a nave in gathering with a disk (subsection 9.3.12, subsection 9.3.13 see). |
| 5. Designate disk position, turn away bolts and nuts and remove a disk. |
| 6. Assemblage is carried out upside-down. Nuts and disk bolts tighten with the moment 52 Н.м. |
|
Condition check
The prevention At detection of strong damages (выкрашивания, задиров, strong development) or in case of the raised palpation a disk replace, the manufacturer disk polishing is not provided.
| PERFORMANCE ORDER |
| 1. Check up disk palpation for 1 turn, having established an indicator leg in 5 mm from disk edge (the support and колодки thus should be removed). |
| 2. Check up a thickness of a disk (the minimum thickness is cast on a disk). |
| 3. If the thickness of a disk measured in 4 points of equal palpation, differs more than on 0,025 mm, or less minimum a disk replace. |
|
|
